AWWA C220 2012

$75.83

AWWA C220-12: Stainless Steel Pipe 1/2 In. (13mm) & Larger

Published By	Publication Date	Number of Pages
AWWA	2012	36

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard pertains to unannealed austenitic stainless-steel pipe that is straight-seam or spiral-seam welded, 1/2 in. (13 mm) in nominal diameter and larger, and that is intended for the transmission and distribution of water and for use in other water-supply system facilities. The purpose of this standard is to provide purchasers, manufacturers, and constructors with the minimum requirements for stainless-steel pipe, 1/2 in. (13 mm) and larger, including fabrication and testing requirements.

PDF Catalog

PDF Pages	PDF Title
7	Foreword I. Introduction. I.A. Background I.B. History I.C. Acceptance
8	II. Special Issues II.A. Basis of Design
9	III. Use of This Standard III.A. Purchaser Options and Alternatives
11	III.B. Modification to Standard IV. Major Revisions
12	V. Comments
13	Section 1 : GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application
14	Section 2: REFERENCES
15	Section 3: DEFINITIONS
17	Section 4: REQUIREMENTS Sec. 4.1 Permeation Sec. 4.2 Materials
18	Sec. 4.3 General Fabrication Requirements Table 1 Mechanical properties for austenitic or duplex stainless steel
19	Sec. 4.4 Specific Fabrication Requirements
20	Figures Figure 1 Repair method by offset value and well thickenss Tables Table 2 Re pair requirements based on offset value and wall thickness
22	Figure 2 Reduced-section tension test specimen Figure 3 Guided-bend test specimen
23	Figure 4 Jig for guided-bend test Table 3 Guided-bend test jig dimensions
24	Figure 5 Alternative guided-bend wraparound jig Figure 6 Alternative guided-bend roller jig
25	Sec. 4.5 Permissible Variations in Weights and Dimensions
26	Sec. 4.6 Preparation of Ends
28	Sec. 4.7 Special Ends Sec. 4.8 Cleaning and Descaling Sec. 4.9 Specials and Fittings Section 5: VERIFICATION Sec. 5.1 Inspection
29	Sec. 5.2 Test Procedures
31	Sec. 5.3 Basis for Rejection Sec. 5.4 Repair of Defects Section 6: DELIVERY Sec. 6.1 Marking
32	Sec. 6.2 Shipping, Storage, and Handling
33	Sec. 6.3 Affidavit of Compliance