ASTM-C874 2011

$35.75

C874-11 Standard Practice for Rotary Slag Testing of Refractory Materials

Published By	Publication Date	Number of Pages
ASTM	2011	3

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM C874-11

Historical Standard: Standard Practice for Rotary Slag Testing of Refractory Materials

ASTM C874

Scope

1.1 This test method describes a procedure for comparing the behavior of refractories to the action of molten slag in a rotating test furnace. A reference material should be included in each test and run for comparison. No numeric results are obtained from this test method. Numeric evaluation of test results is the responsibility of the test operator. The test and equipment are patterned after a method developed by Valley Dolomite Corporation .

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

corrosion; penetration; refractories; rotary; slag; Refractories (general); Rotary slag testing; Slag

ICS Code

ICS Number Code 81.080 (Refractories)

DOI: 10.1520/C0874-11