ASTM-D3454 2011
$40.63
D3454-11 Standard Test Method for Radium-226 in Water
Published By | Publication Date | Number of Pages |
ASTM | 2011 | 9 |
ASTM D3454-11
Historical Standard: Standard Test Method for Radium-226 in Water
ASTM D3454
Scope
1.1 This test method covers the measurement of soluble, suspended, and total radium-226 in water in concentrations above 3.7 × 10−3 Bq/L. This test method is not applicable to the measurement of other radium isotopes.
1.2 This test method may be used for quantitative measurements by calibrating with a radium-226 standard, or for relative measurements by comparing the measurements made with each other.
1.3 This test method does not meet the current requirements of Practice D2777.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.5 Hydrofluoric acid (HF) is very hazardous and should be used in a well-ventilated hood. Wear rubber gloves, safety glasses or goggles, and a laboratory coat. Avoid breathing any HF fumes. Clean up all spills promptly and wash thoroughly after using HF.
1.6 This standard does not purport to address all of the other safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
coprecipitation; emanation; radioactivity; 226Ra; 222Rn; water: Radioactive water analysis; Radium content–water
ICS Code
ICS Number Code 13.060.50 (Examination of water for chemical substances)
DOI: 10.1520/D3454-11
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology Summary of Test Method Significance and Use |
2 | Interferences Apparatus Reagents and Materials TABLE 1 FIG. 1 |
3 | FIG. 2 FIG. 3 |
4 | Sampling Calibration and Standardization |
5 | Procedure |
6 | Calculation TABLE 2 |
7 | Precision and Bias Quality Assurance |
8 | FIG. 4 |
9 | Keywords References |