ASTM-D3763 2023(Redline)

$44.96

D3763-23 Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors (Redline)

Published By	Publication Date	Number of Pages
ASTM	2023

Guaranteed Safe Checkout

Categories: 83.080.01 - Plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3763-23

Redline Standard: Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

ASTM D3763

Scope

1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.

1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: This standard and ISO 6603-2 address the same subject matter, but differ in technical content. The technical content and results shall not be compared between the two test methods.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

falling weight; impact testing; plastics; puncture properties;

ICS Code

ICS Number Code 83.080.01 (Plastics in general)

DOI: 10.1520/D3763-23

Additional information

Standard Title	D3763-23 Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors (Redline)
Published Code	ASTM
Publication Date	2023
ICS Codes	83.080.01 - Plastics in general