🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-D6172:2010 Edition

ASTM-D6172:2010 Edition

$40.63

D6172-98(2010) Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures

Published By Publication Date Number of Pages
ASTM 2010 8
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D6172-98-Reapproved2010

Historical Standard: Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures

ASTM D6172

Scope

1.1 This test method covers procedures concerning site preparation, technical procedures, quality control, and equipment to direct the efforts for determining volumes of bulk material. These procedures include practical and accepted methods of volumetric determination.

1.2 This test method allows for only two volume computation methods.

1.2.1 Contour Test Method—See 8.1.1 and 9.1.

1.2.2 Cross-Section Test Method—See 8.1.2 and 9.2

1.2.3 This test method requires direct operator compilation for both contours and cross-section development.

1.2.4 The use of Digital Terrain Model software and procedures to create contours or cross sections for volume calculation is NOT encompassed in this test method.

Note 1—A task group has been established to develop a test method for Digital Terrain Modeling (DTM) procedures. It will address all known data collection procedures such as conventional ground survey, photogrammetry, geodetic positioning satellite (GPS), and so forth.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system is used independently of the other. Combining values from the two systems can result in nonconformance with the specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aerial; inventory; photogrammetric; photography; stockpile; volume; Aerial analysis; Bulk materials; Coal/coke products; Contours; Cross section data/analysis; Horizontal testing; Inventory analysis/control; Photogrammetric methods; Stockpiles; Volumetric measurement

ICS Code

ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)

DOI: 10.1520/D6172-98R10

PDF Catalog

PDF Pages PDF Title
1 Scope
Terminology
2 Summary of Test Method
Significance and Use
Required Preproject Setup Data
Apparatus
Calibration and Standardization
3 Procedure
4 FIG. 1
5 FIG. 2
6 Calculation
7 Report
Precision and Bias
Keywords
TABLE 1

Related products

ASTM-D6172
$40.63