Shopping Cart

No products in the cart.

ASTM-D7066 2004

$40.63

D7066-04 Standard Test Method for dimer/trimer of chlorotrifluoroethylene (S-316) Recoverable Oil and Grease and Nonpolar Material by Infrared Determination

Published By Publication Date Number of Pages
ASTM 2004 9
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This test method covers the determination of oil and grease and nonpolar material in water and wastewater by an infrared (IR) determination of dimer/trimer of chlorotrifluoroethylene (S-316) extractable substances from an acidified sample. Included in this estimation of oil and grease are any other compounds soluble in the solvent.

1.2 The method is applicable to measurement of the light fuel although loss of some light ends during extraction can be expected.

1.3 This method defines oil and grease in water and wastewater as that which is extractable in the test method and measured by IR absorption at 2930 cm- 1 or 3.4 microns. Similarly, this test method defines nonpolar material in water and wastewater as that oil and grease which is not adsorbed by silica gel in the test method and measured by IR absorption at 2930 cm- 1 .

1.4 This method covers the range of 5 to 100 mg/L and may be extended to a lower or higher level by extraction of a larger or smaller sample volume collected separately.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine (D 3856 Guide for Good Laboratory Practices) the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
Significance and Use
2 Interferences
Apparatus
Reagents
Sampling
3 Preparation of Calibration and Spiking Solutions
Calibration
4 Procedure
5 Calculation
Quality Control (QC)
7 Precision and Bias
8 X1. PRECSION AND BIAS
X1.1
TABLE 1
9 TABLE X1.1
ASTM-D7066 2004
$40.63