🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-E2176:2008 Edition

ASTM-E2176:2008 Edition

$42.25

E2176-08 Standard Test Method for Measuring the Coefficient of Retroreflected Luminance of Pavement Markings in a Standard Condition of Continuous Wetting (RL-Rain)

Published By Publication Date Number of Pages
ASTM 2008 6
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM E2176-08

Replaced Standard: Standard Test Method for Measuring the Coefficient of Retroreflected Luminance of Pavement Markings in a Standard Condition of Continuous Wetting (RL-Rain) (Withdrawn 2013)

ASTM E2176

Scope

1.1 This test method covers a measurement of the wet retroreflective (RL-Rain) properties of horizontal pavement marking materials, such as traffic stripes and road surface symbols.

1.2 This method of measuring wet retroreflective properties (RL) of pavement markings utilizes a method of continuously wetting the marking during measurement (see Fig. 1).

Note 1—Test Method E 2177 may be used to describe the retroreflective properties of pavement markings in conditions of wetness after a period of rain.

1.3 This test method is most suitable for laboratory use under controlled conditions, but may also be used for field measurements when the necessary controls and precautions are followed.

1.4 This test method specifies the use of reflectometers that can measure pavement markings per Test Method E 1710. The entrance and observation angles required of the retroreflectometer in this test method are commonly referred to as “30 meter geometry.”

1.5 This test method has been shown to produce reasonable results for pavement marking systems with optics having an index of refraction greater than 2.0 and structured markings having vertical structures greater than or equal to 3 mm. Users should exercise caution when using this test method for pavement marking systems with optics having an index of refraction less than 2.0 or markings having vertical structures less than 3 mm.

1.6 Results obtained using this test method should not be the sole basis for specifying and assessing the wet retroreflective effectiveness of pavement marking systems. Users should complement the results of this test method with other evaluation results, such as nighttime visual inspections.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2—An alternative test method designed to better represent the retroreflective efficiency of pavement marking systems under typical rain events is under development.

FIG. 1 Illustration of Measurement

Keywords

continuous wetting; dry retroreflection; pavement markings; portable retroreflectometer; wet retroreflection; Geometric analysis–paints/related coatings/materials; Dry retroreflection; Mobile retroreflectometers; Pavement marking materials; Portable retroreflectometers; Retroreflected luminance (RL); Retroreflective marking materials; Wet retroreflective (RL) properties; Coefficient of retroreflection; Continuous wetting conditions

ICS Code

ICS Number Code 93.080.20 (Road construction materials)

DOI: 10.1520/E2176-08

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Significance and Use
Apparatus
FIG. 1
FIG. 2
3 Sampling
Standardization
General Procedure
Test Report
4 Factors That May Influence Measurements
Precision and Bias
TABLE 1
TABLE 2
5 Keywords
X1. EXAMPLES OF PAVEMENT MARKING MEASUREMENT SYSTEMS
X1.1
FIG. X1.1

Related products

ASTM-E2176
$42.25