BS EN 61169-50:2015
$142.49
Radio-frequency connectors – Sectional specification for RF coaxial connectors with inner diameter of outer conductors 4,11 mm with quick lock system. Characteristic impedance 50 Ohm (type QMA)
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 26 |
This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for type QMA R.F. coaxial connectors with quick lock.
The connectors are normally used with 50 Ω corrugated cable and flexible cables for middle power applications in an operating range up to 6 GHz.
It describes the interface dimensions for general purpose connectors with gauging information and the mandatory tests selected from IEC 61169-1, applicable to all detail specifications relative to type QMA connectors.
This specification indicates the recommended performance characteristics to be considered when writing a DS and covers all tests schedules and inspection requirements.
NOTE Metric dimension are original dimensions.
All un-dimensioned pictorial configurations are for reference purpose only.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword Endorsement notice |
| 5 | Annex ZA (normative) Normative references to international publications with their corresponding European publications |
| 6 | English CONTENTS |
| 7 | INTRODUCTION |
| 8 | 1 Scope 2 Normative references |
| 9 | 3 Mating face and gauge information 3.1 Dimensions – General connectors 3.1.1 Connector with socket-centre contact Figures Figure 1 – Connector with socket-centre contact (for dimensions, see Table 1) Figure 2 – Female centre contact (for dimensions, see Table 1) |
| 10 | Tables Table 1 – Dimensions of connector with socket-centre contact |
| 11 | 3.1.2 Connector with pin-centre contact Figure 3 – Connector with pin-centre contact (for dimensions, see Table 2) Figure 4 – Details of pin-centre contact (for dimensions, see Table 2) |
| 12 | 3.2 Gauges for general purpose connectors 3.2.1 Gauge pins for socket-centre contact Figure 5 – Gauge pin for socket-centre contact (for dimensions, see Table 3) Table 2 – Dimensions of connector with pin-centre contact |
| 13 | 3.2.2 Test procedure 4 Quality assessment procedures 4.1 General 4.2 Ratings and characteristics (see Clause 5 of IEC 61169-1:2013) Table 3 – Gauge dimensions for socket-centre contact Table 4 – Rating and characteristics |
| 15 | 4.3 Test schedule and inspection requirements 4.3.1 Acceptance tests Table 5 – Acceptance tests |
| 16 | 4.4 Procedures for the quality conformance 4.4.1 Quality conformance inspection Table 6 – Periodic tests |
| 17 | 4.4.2 Qualification approval and its maintenance 5 Instructions for preparation of detail specifications 5.1 General 5.2 Identification of the component 5.3 Performance 5.4 Marking, ordering information and related matters |
| 18 | 5.5 Selection of tests, test conditions and severities 5.6 Blank detail specification pro-forma for type QMA connector |
| 23 | 6 Marking 6.1 Marking of component 6.2 Marking and contents of package |
