BS EN ISO 13297:2021 – TC
$246.62
Tracked Changes. Small craft. Electrical systems. Alternating and direct current installations
Published By | Publication Date | Number of Pages |
BSI | 2021 | 106 |
This document specifies the requirements for the design, construction and installation of the following types of DC and AC electrical systems, installed on small craft either individually or in combination:
-
extra-low-voltage direct current (DC) electrical systems that operate at nominal potentials of 50 V DC or less;
-
single-phase alternating current (AC) systems that operate at a nominal voltage not exceeding AC 250 V.
This document does not cover the following:
-
electrical propulsion systems of direct current less than 1 500 V DC, single-phase alternating current up to 1 000 V AC, and three-phase alternating current up to 1 000 V AC, which are addressed by ISO 16315 ;
-
any conductor that is part of an outboard engine assembly and that does not extend beyond the outboard engine manufacturers supplied cowling;
-
three-phase AC installations that operate at a nominal voltage not exceeding 500 V AC, which are addressed by IEC 60092-507 .
PDF Catalog
PDF Pages | PDF Title |
---|---|
62 | undefined |
67 | Annex ZA (informative)Relationship between this European Standard and the Essential Requirements of Directive 2013/53/EU aimed to be covered |
70 | Foreword |
71 | 1 Scope 2 Normative references 3 Terms and definitions |
75 | 4 General requirements, DC and AC systems |
76 | 5 General requirements, DC systems |
77 | 6 General requirements, AC systems |
78 | 7 Marking, AC systems |
79 | 8 Batteries, DC systems |
81 | 9 Battery-disconnect switch, DC systems 10 Power source options, AC systems |
82 | 11 Inverters and inverter/chargers, AC systems |
83 | 12 Overcurrent protection, DC systems |
84 | 13 Overcurrent protection, AC systems 13.1 General 13.2 Supply circuits 13.3 Branch circuits |
85 | 14 Ground-fault protection/earth-leakage protection, AC systems 15 Panel boards (switchboards), DC and AC systems 16 Panel boards (switchboards), AC systems 17 Conductors, DC and AC systems |
86 | 18 Conductors, DC systems 19 Conductors, AC systems |
87 | 20 System wiring, DC and AC systems |
89 | 21 System wiring, DC systems 22 Socket outlets, DC systems 23 Socket outlets, AC systems 24 Appliances and equipment, AC systems 25 Ignition protection, DC and AC systems |
90 | 26 Owner’s manual |
91 | Annex A (normative) Conductor requirements |
93 | Annex B (normative) Instructions to be included with owner’s manual |
94 | Annex C (informative) Recommended system tests |
95 | Annex D (informative) Typical AC system diagrams |
102 | Annex E (informative) Overcurrent protection location options |
104 | Bibliography |