BS ISO 3310-2:2013
$102.76
Test sieves. Technical requirements and testing – Test sieves of perforated metal plate
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 18 |
This part of ISO 3310 specifies the technical requirements and corresponding test methods for test sieves of perforated metal plate.
It applies to test sieves having
-
round holes, with sizes from 125 mm down to 1 mm, or
-
square holes, with sizes from 125 mm down to 4 mm,
in accordance with ISO 565.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 8 | Section sec_1 Section sec_2 Section sec_3 Section sec_4 Section sec_5 Section sec_5.1 Section sec_5.1.1 1 Scope 2 Normative references 3 Terms and definitions 4 Designation 5 Perforated metal plate 5.1 Requirements |
| 9 | Section sec_5.1.2 Section sec_5.1.2.1 Section sec_5.1.2.2 Table tab_1 |
| 10 | Section sec_5.1.3 |
| 11 | Table tab_2 Section sec_5.1.4 Figure fig_1 Section sec_5.1.5 |
| 12 | Section sec_5.2 Table tab_3 Figure fig_2 5.2 Test methods |
| 13 | Section sec_5.3 Section sec_5.3.1 Section sec_5.3.2 Section sec_5.3.2.1 Section sec_5.3.2.2 Section sec_5.3.2.3 Section sec_6 5.3 Documentation for sieve conformity 6 Test sieve frames |
| 14 | Table tab_a Figure fig_3 Table tab_4 Section sec_7 7 Marking of test sieves |
| 15 | Annex sec_A Table tab_A.1 Annex A (informative) Test sieve record card |
| 16 | Reference ref_1 Reference ref_2 Bibliography |
