IEEE C63.19 2006
$58.50
Method of Measurement for Hearing Aid Compatibility with Wireless Communications
Published By | Publication Date | Number of Pages |
IEEE | 2006 | 55 |
New IEEE Standard – Active. Revised by ANSI C63.19-2007. Uniform methods of measurement for compatibility between hearing aids and wireless communications devices are set forth.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | ANSI C63.19-2006 Front Cover |
3 | Title Page |
4 | Acknowledgments |
6 | Introduction Participants |
11 | American National Standard Methods of Measurement of Compatibility between Wireless Communications Devices and Hearing Aids 1. Overview 1.1 Scope 1.2 Purpose |
13 | 1.3 Organization and use of the document |
15 | 2. Normative references |
18 | 3. Definitions, acronyms, and abbreviations 3.1 Definitions |
21 | 3.2 Acronyms and abbreviations |
22 | 4. Wireless device, RF emissions test |
23 | 4.1 Measured RF interference level |
24 | 4.2 Test equipment and facilities |
26 | 4.3 Test setup and validation |
31 | 4.4 Near-field test procedure |
39 | 5. Hearing aid RF near-field immunity test 5.1 Test facilities and equipment |
40 | 5.2 Test setup and validation |
42 | 5.3 RF immunity test procedure—primary |
48 | 5.4 RF immunity test procedure—alternate |
51 | 6. Wireless device T-Coil signal test 6.1 Test facilities and equipment |
64 | 7.3 T-Coil coupling mode |
66 | 7.4 Accessories and options |
67 | 7.5 Product line compliance 8. Calibration and measurement uncertainty 8.1 General 8.2 Ambient conditions |
68 | 8.3 Specific calibration requirements 8.4 Measurement uncertainty 9. Test report 9.1 Test plan 9.2 Applicable standards 9.3 Equipment unit tested |
69 | 9.4 Test configuration 9.5 List of test equipment 9.6 Units of measurement 9.7 Location of test site 9.8 Measurement procedures 9.9 Reporting measurement data |
70 | 9.10 General and special conditions 9.11 Summary of results 9.12 Required signatures 9.13 Test report annexes 9.14 Test report disposition |
71 | Annex A (normative) Definition of reference axes |
75 | Annex B (normative) Test frequencies |
77 | Annex C (normative) Equipment and setup calibration |
87 | Annex D (normative) Test equipment specifications |
108 | Annex E (informative) Sample measurement uncertainty estimates |
113 | Annex F (informative) Use of Helmholtz coils for calibration |
121 | Annex G (informative) RF envelope comparison for US WD systems |
126 | Annex H (informative) Explanation of rationale used in this standard |
127 | Annex I (informative) Measurement of peak power across multiple airlink technologies |
135 | Annex J (informative) Sample HAC application forms |
139 | Annex K (informative) Bibliography |